Designed for novice to expert levels
Evaporation measuring device consisting of: a stainless steel cone-shaped sieve 60 mesh, a 200 ml tall form beaker, cover fitted with gasket and crane hook for the Stainless steel oil bath with insulated double wall, cover with two holes for evaporation cells, two flowmeters. stainless steel control box on the cover, temperature controlled by digital thermoregulator PID with PT100 probe class A and overtemperature alarm, stainless steel heater, motor stirrer, safety internal level for low liquid with warning lamp.
The following accessories are recommended for purchase in sequential order (see eStore):
1st Year:
PTFE GASKET, pack of 10 pcs
2nd Year:
Same as 1st year
Remaining Parts:
EVAPORATION CELL Stainless steel cylindrical body with neck flange and three cell connections for the tight cover closure, double bottom with 3.17 mm orifice, brass pre-heating coil with cell connections and air inlet tube, stainless steel cover with PTFE gaskets fitted with 3 blocking screws. Central air flow-off connected to an 18/8 stainless steel tube with lower threaded junction for connection with the test cup.
GREASE SAMPLE CUP For greases
SAMPLE CUP For lubricating oil
FILTERING PIPE Ø25×400 mm, with glass wool
AIR PUMP
ELECTRONIC BALANCE Range 600 g., readout 0.01, pan Ø130
THERMOMETER ASTM 22C IP 24C
THERMOMETER ASTM 67C
FLOWMETER
PROBE PT100A
HEATER
LEVEL SWITHC
DIGITAL THERMOREGULATOR
STATIC RELAY
BIPOLAR GREEN SWITCH
MOTOR STIRRER